Skip to content
Industrial PartitioningCompanyGet a quote
Menu

Industrial Partition Run Planner

Put in the length, the height and the doors, and the planner works out the wall area and an example panel and post count you can hand to installers. Fabric curtain walls also get a rough figure from the one published average.

Your run

Add up every side you need built. A corner cage using two building walls has two sides.

Wall area
44 m²
Example bays at 1,000 mm
20
Posts, before door openings
21
Doorways
1

Priced on survey

No installed rate for this system has been published, so installers price it from a survey. Hand them the figures above.

A guide, not a quote.

Your system, run length and these figures go into the form below.

Reading the numbers

The area is length times height, which is how fabric walls and some panel systems are priced. The bay count assumes a panel every metre, purely as an example, and the posts follow from that: a straight run needs one more post than it has bays, less any that would stand in a wide door opening.

Doors sit in the run in place of panels. A sliding door also needs its track to run past the opening over solid panels, as the example layout below shows, so leave room for it along the wall.

For fabric, the figure is the wall area multiplied by the published average of about £85 per m² (August 2024). Tall walls are likely to come in above it, because the panels are cut narrower to keep each one under 30 kg.

Example layout of a partition run in planPlan view of a 10 metre run split into ten 1,000 mm example bays. Two bays form a 2 m opening with no post in it, for a sliding door whose track runs past the opening over the solid panels, leaving ten posts. Example layout only.Example layoutPlan view, 10 m run, 1,000 mm example bays. Real widths vary by maker.door track runs past the openingdoor leaf, slid open10 m run: 10 bays, 10 posts (none mid-opening)2 m openingpanelpostopening
Example layout only. Your installer sets out the real bay widths, post positions and door sizes on survey.

Questions about the planner

Why does the planner not price mesh or steel?

Because no installed price per metre for mesh or solid steel partitioning has been published that we can stand behind. Rather than invent a rate, the planner gives you the quantities an installer prices from.

Where does the fabric figure come from?

From a UK maker's published cost guide (August 2024), which put PVC-coated fabric partition walls at about £85 per m² on average. Taller walls and walls with many penetrations tend to cost more.

Why 1,000 mm bays?

It is a round example so the sums are easy to follow. Makers offer several panel widths, and the installer will mix them to fit your run.

Do doors change the panel count?

A door takes the place of panels in the run, so you will need fewer panels than bays. The installer works out the exact split once door widths are known.

Will I need building control?

If the wall changes an escape route, a fire compartment or the structure, it may be a material alteration under regulation 3 of the Building Regulations 2010 (England and Wales). Ask building control before you order.

Rules and guidance we drew on

The fabric average comes from a UK maker's published cost guide (August 2024), not linked here because it is a business. The rules below are official sources.

Ask for a partition quote

We look for an installer who fits this kind of system near your site and tell you who they are before any of your details go to them. There is no charge to you.

Step 1 of 3
Where is the building?
Get a quote